This blue pump action shot gun has a 30 inch ventillated rib barrel. Bore is very good condition. 2 3/4 & 3 inch shells.
Front bead is missing. Tang safety. Two piece checkered hard wood stock. There are no major imperfections in the stock however there are minor ones. The stock needs to be refinished to be perfect. If I do it I will raise the price but I think it is well worth the $$$
There are a few being offered at 160-190- this is a steal and a great way to get into a good 12 gauge pump
(Columbus, GA) Great 12 gauge Pump- Springfield M-67 Series E - $145.00
↧
↧
(Chicago) Llama minimax .45 - $400.00
$400 obo
↧
(Dayton) SKS-Norinco - $375.00
Nice Norinco SKS, shoots good and has nice shiny bore. Comes with 30 round magazine
↧
(St. Louis) CETME 308 - $1,800.00
Cetme 308 with illuminated reticle scope. With 7 magazines. 5 are brand new still in wrap. Rifle has performed flawlessly and has been very enjoyable to shoot. Asking 1800 cash or other firearms plus cash. Looking for parts to finish a AR in 308. Thanks for looking.
↧
(Phenix City) 45-70 brass - Make Offer
45-70 brass to reload
↧
↧
(Oklahoma) Olympic Arms AR-15 M4 - $1,800.00
Olympic Arms AR-15 M4. Removable Handle with Elevation and Azimuth dial adjustments, 18 inch barrel, and collapsible stock. All original, 400 rounds fired, no fail to fire or jams. Includes 200 rounds SS109 British 55gr 1990’s manufacture, 3 high capacity magazines.
↧
(Kansas) Hi Point 4095 w/ extras - Make Offer
Wanting to trade only. Has scope, sling, forward grip, 2mags, and a mag holder that mounts on butstock. Has minimal wear but is used.
↧
(Knoxville) Stevens model 62 22lr - $135.00
Its a good shape model 62 Stevens they are like 139 plus TBI and tax you can have this one for $135 flat might be able to find 10 rounds to throw in IF SERIOUS SEND LOCAL 865 NUMBER
↧
(Knoxville) AR15 .223/5.56 - 30 round Magpul GEN III - $35.00
I have 4 - AR15 .223/5.56 - 30 round Magpul GEN II for sale.
$35 each plus shipping unless you pick up locally.
I also have ammo if you need any.
Email or call me at 865-360-5555.
↧
↧
(Lexington) Kimber 82 G Government Issue .22 Cal Target Rifle - $650.00
I have 2 Kimber 82G Government Issue Target Rifles for Sale.
One is NIB unfired with all of the paper work etc. It has an exceptional piece of wood with lots of figure that has been refinished to remove the cut from the stock. Research the history of these if your not familiar- most of them have it. The only reason I refinished it was because the wood is so exceptional. I have cleaned the Cosmoline out of the bolt and trigger assembly. No rust. No rounds have been chambered since it left Kimber of Oregon in the 80s. Beautiful Rifle. $750 cash
The other one is a blond and has less than a brick through it. It is a very good shooter- sub dime size groups at 50 yards with Eley target. I haven't put any high end match ammo but would expect it to be better than that. This was purchased in 2006 and is not one of the "Rustys" currently being sold. It has the expected, although very slight, cut in the forearm from Sargent slasher. $650 Cash
I have the original paperwork from the CMP for both of the rifles.
I got an Anschutz 54.18MS so neither of these guns will get shot. I'm only going to sell one of these and keep the other.
MORE INFO FROM KIMBER
Top quality U.S.-made smallbore target rifles have been a scarce commodity for many years. Winchester decided in the late 1970s that annual sales of the legendary Model 52 target gun, seldom numbering in the hundreds, were insufficient to justify continued production.
Since then the 40X rifles made in Remington's custom shop have been the only smallbore guns made by a major U.S. manufacturer. German makers, especially Anschutz, have dominated the field. Most U.S. manufacturers have abandoned the smallbore target rifle, but a government contract helped Kimber.
With the help of a big U.S. government contract, Kimber of Oregon has set out to change the situation. The firm won a contract to make 20,000.22 rimfire target rifles, all capable of firing .700" or smaller groups at 50 yds. with target ammunition.
With completion of government deliveries near, Kimber now is offering the gun to the civilian market. This rifle differs from the military version only in that the sight set is an optional accessory that most smallbore shooters will, no doubt, want to order with the rifle.
The loading platform of the singleshot Model 82 is inserted in the receiver and incorporates the ejector. The action is securely fastened to the stock by a pair of heavy screws; one through the rear of the steel trigger guard into the rear tang and the other through the handstop rail into the recoil lug. The recoil lug is dovetailed to the receiver, which is grooved to accept the rear sight.
Most of the Australian-made rear sight components are steel, with the housing and mounting bar made of a non-ferrous alloy. The mounting base secures to the corresponding receiver dovetail with two heavy clamping screws. The entire mounting system appears abundantly secure and allows the sight to be removed and reinstalled with minimal impact change.
The adjustment knobs are heavily grooved for easy turning and are located at the top and left side of the sight. Each is clearly marked for direction and scale, allowing easy return to any previous setting. The adjustments are faithful to their claimed 1/5 minute of angle (m.o.a.) increments. No backlash was n6ted.
The front sight is of the standard globe type and is made of a non-ferrous alloy. The 10 interchangeable inserts and the screw-in sight face and back are steel. The three post sizes and seven apertures that make up the front sight insert set seem adequate for shooting at most ranges and under varying light conditions.
The safety lever is typical of Kimber sporting .22s and is "rolled" on and off to positive stops. It cannot be applied unless the action is cocked. The bolt handle is not locked when the safety is applied.
The trigger assembly is fully adjustable for weight of pull, overall travel and sear engagement. The manufacturer cautions against making adjustments before reading and understanding the pertinent instructions; and then that adjustment be undertaken only by an experienced gunsmith or armorer.
The three trigger adjusting screws (accessible after the barrelled action has been removed from the stock) are each provided with two locking screws. An inspection port allows viewing of the sear/trigger engagement.
The instruction book states that rifles are shipped with triggers adjusted to a pull weight between 3.5 and 4.5 lbs., and that the trigger should not be adjusted to less than 2 lbs. Notwithstanding all that, the sample rifle tested at a very crisp 3 lbs., and no further adjustment was deemed necessary.
The instructions further state that the rifle should not be dry-fired, but it may be uncocked by holding the trigger to the rear as the bolt is closed.
The cylindrical 25" barrel, factoryfitted with three sight bases (for scope mounts and the front sight) has a diameter of .928". It has a 1 in 16" righthand twist and is completely freefloated.
The manufacturer warns against the use of all types of Short, Long or hypervelocity cartridges.
Three buttstock spacers allow the length of pull to be adjusted between 117/8" and 133/8". The fore-end's accessory rail accepts the factory-supplied round hand stop. Fit and finish were in keeping with other target arms in this price range. All metal parts were well polished and nicely blued. The walnut stock had some visible figure and a low-luster finish.
↧
(Denver) DPMS Handguard, Trigger guard, DPMS grip and charging handle - $40.00
Hi,
I have some gun parts laying around and won't be using these parts anymore.
These are stock DPMS handguard, trigger guard, DPMS grip, and charging handle.
The parts are pretty much new, I've just replaced them with magpul.
They are for the AR Carbine. Great for someone that needs stock parts or building one.
If your interested please send me a text.
$40 or best offer. I like to sell everything together.
303-304-4981
↧
(Louisville) AR15 Carbine, 5.56 Nato, New in Box, Tactical Rail & Chrome Lined Barrel - $1,299.00
Factory New in Box, Stag Arms, AR15 carbine with factory installed Diamond-Head Versa Rail and front rail on gas block, M4 profile 16" Chrome lined Barrel, 5.56 / .223 caliber. Includes 1 new 30 round magazine, documents, cable lock, and Hardshell case. (Stag Arms Lifetime Warranty)
$1299
↧
(Syracuse) .22LR Federal AutoMatch Ammunition 325rd Boxes - $30.00
I have factory sealed 325 round boxes of Federal AutoMatch .22LR ammunition. It comes bulk packed loose, 325 rounds per box, and the bullets are 40gr with a muzzle velocity of 1200FPS in a rifle.
$30 per box, or $275 for the case of ten boxes. Not interested in "best offer" or trades at the moment.
TERMS: You must be able to legally own this ammunition, over 18, and willing to show proof of ID. If you don't meet these requirements, PLEASE DON'T CONTACT ME. I'm willing to meet within a 30 mile radius; further if you are interested in purchasing the whole case.
↧
↧
(Detroit) AR LOWER 0% FORGING WITH PRINT AND CNC FILE - $125.00
I HAVE A BRAND NEW AR LOWER 7075 FORGING. IT REQUIRES FULL MACHINING. I WILL BE INCLUDING A PRINT AND AN IGS. FILE FOR CNC WORK.
$125.00
313-802-1156
↧
(Greenville) 1952 .38 Colt Cobra revolver - $575.00
I have a 1952 .38 Colt Revolver with slight holster wear. Nice shooting, light snub nose with 6 shots for $575.
↧
(Idaho) ***5.56mm*** BULK LOT OF 240 Winchester 5.56mm 55gr FMJ rounds - $204.00
Will ship out next day UPS GROUND, 100 % legit business and will invoice through PayPal here. Credit cards ad 6% transaction fee, pay pal, USPS money order, no sales tax, but buyer pays SH.
Yes I do have one .223 winchester box in the pic I did see that, I can swap it out if need be just let me know. This is good American made winchester reload able brass cased ammo. White box 55gr FMJ. 20 rounds per box at 12 boxes gives you 240 5.56mm ammo. It's tough to find this and everyplace limits you to 2-5 boxes. So do the math ( your time+ gas+wear and tear on vehicle. It's worth paying more when you figure out all the other costs you spend getting 12
↧
(Oklahoma City) Beretta Px4 .45 Pistol - $545.00
Beretta Px4 .45 Caliber Pistol...$545.00
No emails, please.
Call (405) 605-2006 or come by Best Buy Pawn and Gun in Del City. (4312 SW 29th Street near SE 29th and Sunnylane) - Make sure you mention you saw it on Armslist!
If you are out of state, we can ship these to a FFL dealer. Shipping out of state is $20. Payments can be made using a credit card by phone or with postal money order.
You can also come check out our guns at our store!!
Business Hours:
M - F 9am - 7pm
Saturdays 9am - 5pm
↧
↧
(Denver) New .45 AUTO-RIM Revolver Ammo - NOT ACP - $35.00
500 boxed rounds (50 per box) of Precision Cartridge .45 auto-rim 230gr LRN revolver ammo, brass reloadable cases. This ammo is for .45 revolvers ONLY, no moon clips for this stuff. Straight load-in, eject out. You can save your .45 ACP for your semi-auto pistol.
Bullets are hard cast lead round nose. New ammo, not reloads. Selling for $35 per 50 round box. Price is FIRM whether you buy 1 box or all 10. Text message 303-810-5786 with your phone number. Will meet in Arvada.
Also have 1 box of new 50 rounds of Corbon 230gr .45 auto-rim ammo FMJ, also brass cased for $45. NOT for pistols, revolvers only!
↧
(Pensacola) 16ga buck and slugs, 75rnd AK drum, shotgun an more!! - $1.00
Wanting to sell some 16ga slugs and buckshot
16ga single shot. $140
Drum mag. $175
Saiga 12 brake. $30
.22 mag CCI $10
7.62 x39 silver bear ammo $9.50/box
Taxidermy red fox full body mount awesome! $350
25 round box 12ga federal 2 3/4 00 Buckshot $35/box
Can't post pics so I'll text or email
7067607346. Text only number
↧
(Hampton Roads) B: RUGER MK2 22/45_2MAGS AND 1LOADER@$50 - $50.00
B: two mags and one loader for a RUGER MK2 22/45 in the factory packages for a$50. Payment to be Cash orU.S.POSTAL MONEY ORDER ONLY. Call or text Mike at 757717Three317...
Thanks,
MikeT
↧
More Pages to Explore .....
